User Manual - CODA - Cable Modem14
Chapter 3 Connecting to the Internet
To connect your cable modem to a router after installation and
activation:
1. Reboot your cable modem by unplugging the power cable from
the cable modem and plugging it back in.
Note: Do not disconnect your cable modem from the cable
wall outlet.
When the start-up procedure is completed, the Power LED will turn
solid green. This may take a few minutes to stop blinking and
light solid green.
2. Use an Ethernet cable to connect the Ethernet port on your cable
modem to the WAN or Internet port on your router.
3. Power on the router.
Wait until the router is ready (check your router’s instruction manual
to determine when its ready).
4. Connect a computer to the router over a WiFi connection or with
an Ethernet cable to a LAN port on the router.
To Next Page
Loading...
Need help?
General
