Deutsch / English / Français / Español / Italiano / Nederlands / Polski
-68-
Error code InspectionsCode meaning
Battery Undervoltage
Motor Failure
Controller Failure
Communication Receiving
Failure
Communication
Sending Failure
E00 Normal Status
E06
E07
E09
E10
E11
Check the rear wheel motor wiring for
damage, if the error code still appears after
replugging or damaged, the motor will need to
be replaced.
Check that the battery is fully charged. If this
error code still appears after a full charge you
need to replace the battery.
Check all wiring on the controller for damage, if
the error code still appears after replugging or
damaged, the controller will need to be
replaced.
1.Check whether there is any damage in the
display wire.
2.Check whether the controller and display
plug connection is intact.
3. Unplug the power sensor to see if it reports
error, not report that is the sensor short-circuit
damage, need to replace the sensor.
4. Unplug the motor line to see if the error, not
reported that the motor hall short circuit
damage, need to replace the motor to solve
the problem.
5. The above can not solve the problem with
the replacement method, replace the
controller or display to troubleshoot the
problem.
1.Check whether there is any damage in the
display wire.
2.Check whether the controller and display
plug connection is intact.
3. Unplug the power sensor to see if it reports
error, not report that is the sensor short-circuit
damage, need to replace the sensor.
4. Unplug the motor line to see if the error, not
reported that the motor hall short circuit
damage, need to replace the motor to solve
the problem.
5. The above can not solve the problem with
the replacement method, replace the
controller or display to troubleshoot the
problem.
Error codes and troubleshooting solutions
To Next Page
