E1 Series Servo Drive EtherCAT(CoE) Communications Command Manual About this Manual
HIWIN MIKROSYSTEM Corp. 1-3
1.3 General precautions
This manual is for E1-series CoE drive. Before using the product, please carefully read through this manual.
HIWIN Mikrosystem (HIWIN) is not responsible for any damage, accident or injury caused by failure in
following the installation instructions and operating instructions stated in this manual.
Do not disassemble or modify the product. The design of the product has been verified by structural
calculation, computer simulation and actual testing. HIWIN is not responsible for any damage,
accident or injury caused by disassembly or modification done by users.
Before installing or using the product, ensure there is no damage on its appearance. If any damage
is found after inspection, please contact HIWIN or local distributors.
Carefully read through the specification noted on product label or technical document. Install the
product according to its specification and installation instructions stated in this manual.
Ensure the product is used with power supply specified on product label or in product requirement.
HIWIN is not responsible for any damage, accident or injury caused by incorrect power supply.
Ensure the product is used with rated load. HIWIN is not responsible for any damage, accident or
injury caused by improper usage.
Do not subject the product to shock. HIWIN is not responsible for any damage, accident or injury
caused by improper usage.
If an error occurs in the drive, please refer to “E1 Series Servo Drive User Manual” and follow the
instructions for troubleshooting. After the error is eliminated, power on the drive again.
Do not repair the product by yourself when it malfunctions. The product can only be repaired by
qualified technician from HIWIN.
To Next Page
Loading...
Need help?
General
