HKS EVC - Wiring and Component Mounting

(１)PullthewhiteconnectoroftheExtensionHarnessfromtheenginecompartmentinto
thevehicleinteriorandconnectittothe5PINconnectoroftheEVCMainHarness.
(２)ConnecttheExtensionHarnesstothe5PINConnectoroftheEVCSteppingMotor.
(３)ConnecttheEVCMainHarnesstothe3PINConnectoroftheDisplayUnit.
(４)ConnecttheredwireofthePowerHarnesstotheignitionwireusingasplice.
（ａ）Reconnectthenegativebatterycabletothebatteryterminal.
（ｂ）Turntheignitionswitchonandfindthewiregenerating12vusingatestlight.
（ｃ）Removethenegativebatterycablefromtheterminalofthebattery.
(５)ConfirmthelocationsofthethrottlesignallineandtheengineRPMsignallineor
thespeedsignallineofthevehicle'sharnessthatconnectstotheECU.Connect
thebluewireoftheInputSignalHarnesstothethrottlesignalline,andthewhite
wiretotheengineRPMsignallineorthespeedsignallineusingsplices.Referto
thefactoryservicemanualforsignallinelocations.
 Advice
・IfaspeedlimiterreleasedevicesuchastheHKSSLDisalreadyinstalledon
thevehicle,connectthewhitewireoftheinputsignalharnesstothesidetowards
thevehicle'sharnessfromthedevice.
・Donotconnectunusedsignallines.
(６)ConnecteachinputsignalwiretothesamecoloredwiresontheMainHarness.
(７)Connectthegroundwire(Black).
−23−
３．Wiring
３．１．InstallingSplices
①Strip5mmofthewiringinsulatorforwiring.
②Connectanotherwiretotheuncovered
portionbytwistingthewirestogether.
③Stakethetwistedwiresusingasplice.
④Coverthespliceandwireswith
electricaltapetoinsulate.
Strip5mmofcover
Twistwirestogether
Stakethewires
usingasplice
Insulatewith
electricaltape
３.２.Wiring
EngineCompartmentVehicleInterior
ＥＶＣSteppingMotor
5PINConnector
（Black）
5PINConnector(White）
ExtensionHarness
4PINConnector(White）
ＥＶＣDisplayUnit
PowerHarness
Speed/RPMInputSignal(White)
Main
Harness
ScrambleHarness
ThrottleInputSignal(Blue)
www.R33-GTR.org