– 5 –
room is amply exhausted. Refer to pages 11 - 12 for venting and hood requirements. Verify
with local code ofcials for nal determination.
Models AM16-ASR, AM16T-ASR, AM16VL-ADV, AM16VLT-ADV and AM16-SVLT
are equipped with an Automatic Soil Removal (ASR) system. The ASR system automatically
redirects food soil left over after pre-scrapping to an external scrap basket located at the right
side of the machine (accessory available for left hand installation). This helps to keep the
wash water cleaner, reducing the frequency of water changes. This saves water, energy, and
chemicals. The AM16-ASR-Series machines are only available in hot water sanitizing mode.
Models AM16VL-ADV, AM16VLT-ADV and AM16-SVLT require a single cold-water supply
and come equipped with a drain water energy recovery system which includes drain water
tempering. They utilize a heat exchanger to capture the energy from the drain water and
preheat the incoming cold water for the nal rinse. The AM16VL-ADV, AM16VLT-ADV and
AM16-SVLT are also equipped with an ASR system.
INSTALLATION
UNPACKING
Immediately after unpacking the dishwasher, check for possible shipping damage. If this
machine is found to be damaged, save the packaging material and contact the carrier
within 5 days of delivery.
NOTE: Use caution when using a forklift to remove machine from skid. DO NOT use door
lift handle to move machine, as it will cause door lift issues.
Prior to installation, test the electrical service to ensure it agrees with the specications
on the machine data plate. The dishwasher data plate is located at the lower right hand
corner of the machine.
INSTALLATION CODES
Installation must be in accordance with state and local codes and the National Electrical
Code ANSI/NFPA70 (latest edition). In Canada, the installation code is CSA 22.1 (latest
edition).
To Next Page
Loading...
Need help?
General
