11
6.4 Priming of suction hose detergent
(only with built in detergent pump)
To prime the detergent suction hose between the injector and
container:
– Close hood.
The temperature indicator Rinse
➅
displays:
"SF1" = Priming of detergent suction hose.
– Push and hold Start button
➁
for 1 minute approx.
6.5 Priming of suction hose rinse agent
To prime the rinse agent suction hose between the injector and
container:
– Push Program button
➃
again.
The temperature indicator Rinse
➅
displays:
"SF2"= Priming of rinse agent suction hose.
– Push and hold Start button
➁
for 3 minutes approx.
By using external container with a longer suction hose, hold the
Start button
➁
about 6 minutes.
7 Operation
7.1 Preparation
– Check correct position of rack guides, wash / rinse arms and
strainers.
– Open shut-off valve, switch on main switch or put the
plug in.
– Check level of detergent and rinse agent containers.
– Close hood and push the ON button
➀
, tank will be filled.
The Start button
➁
illuminates red during fill and heating cycle.
This process can take several minutes (machines with built in
softener, adjusted to water hardness H02 or H03 need approx.
40 minutes).
When the Start button changes to green light, machine is ready
for operation.
To Next Page
Loading...
Need help?
General
