Hobart FT1000 - Dishwashing Process

– 6 –
PressthePowerkeyonthekeypadlocatedonthedoorofthecontrolbox(Fig.9).
Thedisplaywilllightup.
POWER
Fig. 9
Ifdoor(s)arenotclosed,Door(s) Opendisplays.Ifdrain(s)arenotclosed,Drain(s)
Opendisplays.Ifalldoorsanddrainsareclosed,Tank(s) Fillingdisplaysandtanks
begintoll.
NOTE: Openingadoorduringthellcycleshutsoffthellvalves…Door(s) Open
displays.Closethedoortoresumethellcycle(Tanks Fillingdisplays).
Afterthewaterlevelraisestheloweroatineachtank,thewash,rinseanddual
rinsetanksbegintoheat.Whenalltanksarefullthellvalveswillautomatically
shutoffandthewatertemperaturesdisplayforeachtank.
TheMaintenanceFillfeatureaddswatertothetankstomaintainproperwaterlevels
duringoperation.Ifthewaterleveldropsbelowtheloweroatinanytank,theheat
shutsoffandllingresumesontheaffectedtank(s).Whenthewaterlevelreaches
theloweroat,heatingresumeswhilethetank(s)continue(s)llinguntiltheproper
waterlevelisreached.
DISHWASHING
Startthemotorsfortheconveyor,pumpsandblowerdryer(ifequipped)bypressing
thegreenSTARTswitchlocatedateithertheloadorunloadendofthemachine
(Fig.10)oronthekeypadlocatedonthefrontofthecontrolbox(Fig.11).The
machinewilloperateonlyifthetankshavelledtotheproperlevelandalldoors
areclosed.PresstheredSTOPswitch(Fig.10or11)tostoptheconveyor,pumps
andblowerdryermotors.
STOP (red)
START (green)
START
STOP
Fig. 10 Fig. 11