EasyManua.ls Logo

Hobart FT1000 - Strainer Basket Maintenance; Loading Dishes Onto Conveyor

Hobart FT1000
84 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
– 7 –
Alltanktemperaturesdisplayonthekeypaddisplaywhenthemachineisinoperation.
FinalRinsetemperaturereads‘---‘untilwarereachestherinsezone.Whenware
reachestherinsezone,theFinalRinsewatertemperaturedisplays.Aftertheware
exitstherinsezone,FinalRinsetemperatureagainreads‘---‘.
Ifwarereachestheunloadendofthemachineandtripsthedishlimitswitch,the
conveyorandnalrinseshutoff,andthekeypaddisplaysthetanktemperatures
alongwithUnload Dishes across the bottom. After the ware is removed and the
dishlimitreturnstooperatingposition,normaloperationresumes.Ifwareisnot
unloaded,theDishLimitAuto-Timercountsdownforoneminute,andthenshuts
offpumpsandblowerdryer(ifequipped).Thedisplaycontinuestoshowthetank
temperatures and Unload Dishes.
Ifnowareentersthemachineforapresetamountoftime,theAuto-Timerautomatically
shutsoffthemachineandtankscontinuetomaintainrequiredtemperatures.To
resumeoperation,pressthegreenSTARTswitchlocatedateitherendofthemachine
oronthekeypadlocatedonthefrontofthecontrolbox.
NOTE: The Auto-Timer shut off setting can be adjusted as shown in the Parameters
Menu(page20);therangeisfrom1to30minutes.
Empty Strainer Baskets As Necessary
Thestrainerbasketscanllwithfoodsoilduringoperationwhichwillaffectdishwasher
operationandthereforemustbeemptiedperiodically.STOPthemachineandopen
theaccessdoors;strainerbasketsareimmediatelyinsideatthefrontofthetanks.
Theexternalscrapbasket(s)attheloadsectionneedstobeemptiedperiodically,
andcanbedonewithoutinterruptingmachineoperation.Removethebasket(s)
whenlledwithfoodsoil,emptyandreplacewhendone.
Loading
Pre-scrapdishesthoroughlytoremovelargefoodparticlesanddebris.Neveruse
steelwoolonwaretobeloadedintothedishwashingmachine;thiscouldintroduce
surfacecorrosionwhichcouldeventuallyinterferewithmachineoperation.
Allplates,saucers,trays, etc.should beloadedontheconveyorin an inclined
position. Bowls should beloaded upside down. Silverware must be washedin
rackstopreventlossofitems;failingtodosocouldcausetheconveyortojamand
damage ware or machine components.
DONOTattempttowashlargeitems(pots,pans,trays,etc.)withoutrstchecking
tomakesuretheytthroughthemachineopening.Suchitemsmustnotbewashed
inthedishwasherunlesstheywilleasilypassthrough.
Donotallowforeignobjectstoentertheunit,especiallymetalliccontaminants.

Other manuals for Hobart FT1000

Related product manuals