Hobart FT900 - OPERATION; Machine Preparation

– 3 –
Pump Intake Screens must be put on
holders at each pump intake (Fig. 1).
Fig. 1
Strainer Pans must be in place on top of
each tank (Fig. 2).
Fig. 2
End Caps must be correctly installed at
ends of all Wash Arms (Fig. 4).
Fig. 4
Wash Arms must be properly installed
and latched in place (Fig. 5).
Fig. 5
The Final Rinse Arm (and Dual Rinse Arm when
present) must be properly installed (Fig. 7).
Fig. 7
Curtains and drainback pans must be in their
proper places, refer to pages 11 – 14.
Strainer Baskets must be in place in
Strainer Pans (Fig. 3).
Fig. 3
The Flush Arm at load end must be
properly installed (Fig. 6).
Fig. 6
Operation and Care of
FT900 SERIES DISHWASHERS
SAVE THESE INSTRUCTIONS
OPERATION
MACHINE PREPARATION — Check before beginning operation.
Open the machine doors and make sure all components are in their proper operating positions.