Hobart FX series - Priming the Suction Hoses

10 06.08.2010 BA-21426-002-EN
EN
3.4. PRIMING THE SUCTION HOSES
Attention:
The machine has to be switched off.
Is carried out automatically if chemical sensor is activated, but will take
several wash cycles. Therefore, we recommend manual hose priming
as follows:
– Open the door.
– Push Stop button
➃
and Program button
➁
simultaneously until
• the upper display
➅
shows “CH1” and
• the lower display
➄
shows “2.50”.
– Push Program button repeatedly, until
• the upper display shows “d” and
• the lower display shows “0”.
– Close the door.
• The upper display shows “SF1”,
• The lower display shows “0”.
3.4.1. DETERGENT SUCTION HOSE
– Pushing the ON/OFF button
➀
activates the hose priming for 65
seconds.
– Check the fill level thereafter, and if necessary, repeat.
– Each cycle can be interrupted by pushing the ON/OFF button again.
3.4.2. RINSE AID SUCTION HOSE
– Push the Program button
➁
.
• The upper display
➅
shows ”SF2”,
• The lower display
➄
shows “0”.
– Pushing the ON/OFF button
➀
activates the hose priming for 80
seconds.
– Check the fill level thereafter, and if necessary, repeat.
– Each cycle can be interrupted by pushing the ON/OFF button again.
3.4.3. TERMINATION OF HOSE PRIMING
– Open door and close it again, or do not press any button for
10 seconds!
3. START-UP