BA-21426-002-EN 06.08.2010 11
EN
3.5. SOFTENER (OPTIONAL)
NOTE: For the first run, the softener has to be filled with regeneration
salt and potable water.
Attention:
Filling the salt reservoir with cleaning agent will damage the
water softener.
– Open the door.
– Unscrew the softener lid and fill with 2 kg of “Granular regeneration
salt” using a funnel (do not use salt tablets).
– Fill up the softener with potable water (only at the first run).
– Clean seal and rim of softener lid carefully, before closing the lid.
– Close lid and tighten.
– In order to prevent corrosion it is necessary to remove any
salt residues from tank bottom.
– Adjust the water hardness according to section 8.3.!
– When the Salt indicator
➆
illuminates during operation, the soft-
ener has to be refilled with regeneration salt.
– There will be a slight delay before salt light extinguishes after refill.
3. START-UP
To Next Page
Loading...
