BA-21870-001-GB 08.10.2010 11
GB
Attention:
Head height of dosing pump: max. 1.5 m
Do not swap containers !
Use only commercial detergent and rinse aid. Please pay
attention to the manufacturers safety instructions.
4.1. DETERGENT
Attention:
Do not use any acidic detergent products with the built-in deter-
gent pump! (The ph-value has to be higher than 7.)!
! Place the suction hose into the bottom of the detergent container.
! Fill the suction hose according to section 4.4.
4.2. RINSE AID
! Place the suction hose (marked blue) into the bottom of the deter-
gent container.
! Fill the suction hose according to section 4.4.
4.3. CHEMICAL DEFICIENCY SENSOR
Attention:
All below-mentioned steps must be carried out by service tech-
nicians qualified by Hobart.
Before removing the housing, make sure the machine is volt-
age-free. Make sure to observe all precautionary measures
required when working near live components.
! Carry out hose filling SF1 and SF2 via the customer menu (see
section 4.4.).
! Watch both hoses until the sensor-operated filling is completed.
! The control LEDs must light up. If necessary, readjust the potenti-
ometers (increase setting).
• Factory setting: potentiometer setting for detergent = 3
• Factory setting: potentiometer setting for rinse aid = 5
! Activate the sensor by using CH = “1” in the customer menu (see
section 9.7.).
Klarspüler
Reiniger
4. START UP
To Next Page
Loading...
