Hobart UP series - Priming Suction Hoses

12 08.10.2010 BA-21870-001-GB
GB
4.4. PRIMING THE SUCTION HOSES
Attention:
The machine has to be switched off.
Is carried out automatically if chemical sensor is activated, but will take
several wash cycles. Therefore, we recommend manual hose priming
as follows:
! Open the door.
! Push Stop button
➃
and Program button
➁
simultaneously until
• the upper display
➅
shows “CH1” and
• the lower display
➄
shows “2.50”.
! Push Program button
➁
repeatedly, until
• the upper display shows “d” and
• the lower display shows “0”.
! Close the door.
• The upper display shows “SF1”,
• The lower display shows “0”.
4.4.1. DETERGENT SUCTION HOSE
! Pushing the ON/OFF button
➀
activates the hose priming for 80
seconds.
! Check the fill level thereafter, and if necessary, repeat.
! Each cycle can be interrupted by pushing the ON/OFF button again.
4.4.2. RINSE AID SUCTION HOSE
! Push the Program button
➁
.
• The upper display
➅
shows ”SF2”,
• The lower display
➄
shows “0”.
! Pushing the ON/OFF button
➀
activates the hose priming for 160
seconds.
! Check the fill level thereafter, and if necessary, repeat.
! Each cycle can be interrupted by pushing the ON/OFF button again
4. START UP