Wing Assembly
2) Trim micro aileron horn at 3rd ring (Barb)
Prevents horn from protruding through top of
wing.
3) Using a 1/16” (1.5mm) drill bit, drill a hole
manually from the underside of the aileron. Use
your finger placed on the top surface to prevent
drilling through the covering
8) Install landing skids on bottom of wing. These
are a wear item and will need to be replaced
periodically.
**Build Note** Center servos and
install control arms on servos prior
to gluing into wing.
4) Glue micro control horns to bottom of wing,
and aileron servos to wing using thick CA.
5) Install micro pushrods. Suggest placing the
U-bend towards the wing surface to prevent
catching upon landing.
1) Use two hinges per aileron. Check that there are slots for hinges. Cut slots as necessary with a
sharp hobby knife.
Glue hinges first to aileron with thin CA. When dry, glue to wing, checking for even gap on aileron
ends to ensure free movement.
6) Mount Bungee hook block by removing covering from top of the wing in shape of bungee
hook block. Block should be even with front of wing. Glue in place with Epoxy.
**Build Note** Mount may need to be tapered to properly
clear the ducting. Check fit before gluing to the wing.
7) Screw in bungee hook from bottom. Hole may
need to be drilled out for proper fit. A dab of epoxy
can be used to further secure hook to block.
5 6
To Next Page
Loading...
