A-24
Unable to find file
Unable to Find Line by Line d0's
Unable to Find Previous Analysis Results
Unable to Open Tissue Calibration File ________
Unable to open temporary file ________
Unable to open temporary Q-File
Unable to Position File to HALO Record
Unable to Position Data File
Unable to Position File: ________
Unable to Position Patient File
Unable to Position Patient File Past Record __
Unable to Position Patient File To End
Unable to Position Scan File Past Record __ (__)
Unable to Position Q-Data File
Unable to Read Data File
Unable to Read File: ________
Unable to Read Line by Line d0's
Unable to Read Previous Analysis Results
Unable to Rewind Q-File
Unable to Rewind File: ________
Unable to Read BMD Image Frame
Unable to Read HALO Frame Header
Unable to Read Q-Data File
Unable to Write to Q-Image File
Hardware
or
Software
These messages indicate problems performing I/O operations (usually to the hard
drive, but possibly to diskette or optical).
Action: Ensure that there is adequate space on the hard drive (Check the "Room for ..."
message in the status window. You should always leave room for 1 or 2 scans). There
may be a disk problem; appropriate diagnostics should be run. If you are unable to find
a hardware problem, the message should be reported to Hologic Technical Support.
Include as much information as possible about what you were doing at the time.
ERROR MESSAGE
HARDWARE
/SOFTWARE
ERROR
LOCUS COMMENT/ACTION
To Next Page
Loading...
