Holtek HT48R05A-1 - Installation; System Requirement; Hardware Installation; Software Installation

Installation
System Requirement
The hardware and software requirements for installing HT-IDE3000 system are as follows:
·
PC/AT compatible machine with Pentium or higher CPU
·
SVGA color monitor
·
At least 32M RAM for best performance
·
CD ROM drive (for CD installation)
·
At least 20M free disk space
·
Parallel port to connect PC and HT-ICE
·
Windows 95/98/NT/2000/XP
Windows 95/98/NT/2000/XP are trademarks of Microsoft Corporation.
Hardware Installation
·
Step 1
Plug the power adapter into the power connector of the HT-ICE
·
Step 2
Connect the target board to the HT-ICE by using the I/O interface card or flat cable
·
Step 3
Connect the HT-ICE to the host machine using the printer cable
The LED on the HT-ICE should now be lit, if not, there is an error and your dealer should be con
-
tacted.
Caution
Exercise care when using the power adapter. Do not use a power adapter whose output voltage is
not 16V, otherwise the HT-ICE may be damaged. It is strongly recommended that only the power
adapter supplied by Holtek be used. First plug the power adapter to the power connector of the
HT-ICE.
Software Installation
· Step1
Insert the HT-IDE3000 CD into the CD ROM drive, the following dialog will be shown.
Chapter 5 MCU Programming Tools
89