Holzmann TS 250 - 16 MAINTENANCE AND CARE; General Maintenance and Care

MAINTENANCE AND CARE
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 46
Tischkreissäge / table saw TS 200 / TS 250
 Use the push stick at the end of cutting when the distance between the saw blade and the pa-
rallel ruler is less than 120 mm.
 Make sure that the machine is working without vibrations.
 Cracked and deformed circular saw blades can not be repaired. You need to be sorted out im-
mediately as a committee and be replaced by ordinary.
 Then the circular saw blade must be removed from service.
 Select the number of teeth of the circular saw blade such that at least 2-3 teeth work simulta-
neously). If only one tooth works, a poor working surface results, the risk the vibrations and
the noise exposure increases before setback increase.
16 MAINTENANCE AND CARE
ATTENTION
Don’t clean or do maintenance on the machine while it is still connected to the pow-
er supply:
Damages to machine and injuries might occur due to unintended switching on of the
machine!
Therefore: Switch the machine off and disconnect it from the power supply before
any maintenance works or cleaning is carried out
The machine is low maintenance and contains little parts that must undergo a maintenance oper-
ator.
Faults or defects that may affect the safety of the machine, must be rectified immediately.
Repair work may only be performed by qualified personnel!
The complete and utter cleaning ensures a long life for the machine and represents a safety re-
quirement.
After each shift the machine and all its parts must be thoroughly cleaned by the dust and swarf
sucked through the suction system and all other waste is disposed of by compressed air.
Check regularly that all warning and safety instructions on the machine and available in a perfect-
ly legible condition.
Check before every use the perfect condition of the safety devices.
For storage of this machine may not be stored in a humid room and must be protected from the
influence of weather conditions.
 The elimination of defects does your dealer
 Repair work may only be performed by qualified personnel!