Common malfunctions and solutions
Treadmill
does
not work
Unplug Connect the power cord
Safety loc k is not in the
right p l ace
Put the emergency stop device on the right
place in control panel
Single wire or power
supply broken
Check signal wire
Switch off Switch on
Running belt dose
Not move
smoothly
Not enough lubricating Lubricate with silicone o i l
Running belt is too tight
Adjust the intensity of the running belt
E01
Control panel does not
work
Check whether the commun i cating wire is broken or
unplug
E02 Comm
unication error
1. The main cable interface is loose;
2. The electronic watch is broken;
3. The controller is damaged;
E04 Motor running error
1. Check if the motor line is inserted, please
re-insert the motor line
2. 2 to check if the motor is operating properly;
replacing the mo tor
3. check if there is a odor; replace the co ntroller
E05
Over current
protection
Turn off the product and turn on again the product
will be ok.
E06
Over voltage protection Turn off the product and turn o
n again the product
will be ok.
E07 Safety lock disconnected
1. The safety switch is not installed;
2. The induction wire of the safety switch is broken;
3. The safety switch interface of the electronic meter
is damaged;
-15-
To Previous Page
Loading...
