11
OTHER FEATURES
1. Auto-restart
If the unit loses power, it will automatically restart with the last settings used, once power
resumes.
2. Louver Angle Memory
3. Refrigerant Leakage Detection
when the unit detects any refrigerant leakage.
4. Sleep Mode
• This function is used to decrease energy use and also helps ensure you sleep comfortably. It
can only be activated via remote control and is not available in FAN or DRY mode.
• Press the SLEEP button when you are ready to sleep. When in COOL mode, the unit will increase
the temperature by 2°F (1°C) after 1 hour, then increase an additional 2°F (1°C) after another
hour. When in HEAT mode, the unit will decrease the temperature by 2°F (1°C) after 1 hour, then
decrease an additional 2°F (1°C) after another hour. The sleep feature will stop after 8 hours and
Set
Temperature
1hr
1hr
Keep
Running
SLEEP Operation
Saving Energy During Sleep
Heat Mode (-2°F/1°C) Per Hour
for the First Two Hours
Cool Mode (+2°F/1°C) Per Hour
for the First Two Hours
5.
When the Follow Me feature is activated, the remote will then act as the thermostat instead of
the unit, helping the unit more accurately cool to your desired temperature based on the ambient
temperature in the area where the remote is located.
• To activate the Follow Me feature, point the remote control towards the unit and press the
"Follow Me" button. The remote will display the actual temperature at its current location. The
remote control will send this signal to the air conditioner every 3 minutes until the Follow Me
button is pressed again. If the unit does not receive the Follow Me signal during any 7-minute
interval, the unit will beep to indicate the Follow Me mode has ended.
• To deactivate this feature, just press the FOLLOW ME button again.
Operating Instructions
To Next Page
Loading...
