36
Installation
Wire Connection
1. Remove the wire cover from the unit by loosening the 3 screws.
2. Remove the caps on the conduit panel.
3. Temporarily mount the conduit tubes (not supplied) on the conduit panel.
4. Properly connect both the power supply and low voltage lines to the corresponding terminals on the
terminal block.
5.
6. Be sure to size each wire for allowance. (They should be several inches longer than the required
length for wiring.)
7. Use lock nuts to secure the conduit tubes.
G
Wire Cover
Over 1.57 in
Terminal Block
Conduit Panel
Connecting Cable
Power Supply Cord
Please select the appropriate through-hole
according to the diameter of the wire.
To Next Page
Loading...
