16
HOW TO USE THE BUTTONS
Ensure that the unit is plugged in and powered on. The OPERATION
1. Press the MODE button and select “Auto”.
2. Press the TEMP or button to set the desired temperature.
The temperature can be set within a range of 62°F~86°F in 1°F
increments.
3. Press the ON/OFF button to start the operation.
Note:
- In Auto Mode, the air conditioner can be programmed to run in Cooling,
Fan, or Heating Mode by detecting the room temperature and the set
temperature.
- In Auto Mode, you cannot select fan speed as it is automatically
controlled.
- If Auto Mode is not comfortable for you, select another mode.
Ensure that the unit is plugged in and powered on.
1. Press the MODE button to select among “COOL”, “HEAT,” (cooling &
heating models only), and “FAN” Mode.
2. Press the TEMP or buttons to set the desired temperature
within 62°F~86°F in 1°F increments.
3. Press the FAN
“Auto”, “Low”, “Med”, and “High”.
4. Press the ON/OFF button to start the operation.
Note:
In FAN Mode, you cannot set the temperature. In this case, only steps 1, 3,
and 4 can be performed.
Ensure that the unit is plugged in and powered on. The OPERATION
1. Press the MODE button to select “DRY” mode.
2. Press the TEMP or buttons to set the desired temperature
within 62°F~86°F in 1 °F increments.
3. Press the ON/OFF button to start the dehumidifying operation.
Note:
In Dehumidifying Mode, fan speed is automatically controlled and cannot
be changed.
Operating Instructions
SILENC E
FP
MODE
FAN
TEMP
ON/OF F
TIMER
ON
TIMER
OFF
3
1
2
LED FOLL OW
ME
TURBO SE LF
CLE AN
SWING DIR ECT
SLEEP
MODE
FAN
TEMP
ON/OF F
SILENC E
FP
TIMER
ON
TIMER
OFF
3
1
2
LED FOLL OW
ME
TURBO SE LF
CLE AN
SWING DIRECT
SLEEP
MODE
FAN
TEMP
ON/OFF
TIMER
ON
TIMER
OFF
4
1
3
2
SILENCE
FP
LED FOLL OW
ME
TURBO SE LF
CLE AN
SWING DIRECT
SLEEP
To Next Page
Loading...
