x10x10
VI
4
VI
4
3
2
4
1
3
2
4
VI
66
VI
1
2
3
1
1
2
3
4
STARTING A COLD ENGINE
1. Lay the product on the ground. Press the
primer bulb 10 times.
NOTE: After the 7th press, the fuel
should be visible in the primer bulb. If
not, continue pressing until the fuel is
visible.
2. Set the choke lever to choke
position.
Squeeze the throttle lock and throttle
trigger completely and pull the starter
grip until the engine attempts to start.
Do not pull the starter grip more than 4
times.
3. Set the choke lever to position. Pull
the starter grip until the engine starts.
Do not pull the starter grip more than 6
times.
NOTE: If the engine does not start,
repeat the procedure again from setting
the choke lever to choke
position.
4. Allow the engine to run for 10 seconds,
then set the choke lever to position.
16
To Next Page
Loading...
Need help?
General
