42
Hazard information
Do not use the device if there are signs of damage
to the housing, control elements or connecting
sockets, for example. If you have any doubts,
have the device checked by an expert.
The device may only be operated in dry and dust-
free environment and must be protected from
the eects of moisture, vibrations, solar or other
methods of heat radiation, excessive cold and
mechanical loads.
The device is not a toy; do not allow children to
play with it. Do not leave packaging material lying
around. Plastic films/bags, pieces of polystyrene,
etc. can be dangerous in the hands of a child.
We do not assume any liability for damage to
property or personal injury caused by improper
use or the failure to observe the hazard
information. In such cases, any claim under
warranty is extinguished! For consequential
damages, we assume no liability!
The actuator is part of the building installation.
The relevant national standards and directives
must be taken into consideration during planning
and set-up. The device has been designed solely
for operation on a 230V/50 Hz AC supply.
To Next Page
Loading...
Need help?
General
