44
Hazard information
For secure operation, the device has to be
installed in a power distribution panel according
to VDE 0603, DIN 43871 (low-voltage sub-
distribution board), DIN 18015-x. The installation
must be carried out on a mounting rail (DIN rail)
according to EN 60715. Installation and wiring
have to be performed according to VDE 0100
(VDE 0100-410, VDE 0100-510 etc.). Please
consider the technical connection requirements
(TAB) of your energy supplier.
Before installation and connection of the device,
mains voltage must be disconnected and live
parts in the surrounding must be covered.
Risk of electric shock. Device has not been
designed to support safety disconnection. Also in
case of disconnected output, the load is not
isolated from the mains.
Do not connect lights with integrated dimmer.
Device may be damaged.
Risk of electric shock. Before starting to work on
the device or exchanging lamps, disconnect
mains voltage and switch o the miniature
circuit-breaker.
To Next Page
Loading...
