46
Hazard information
Devices with electronic power supply units (e.g.
high voltage LED light sources) are no ohmic
loads. They can generate inrush currents with
more than 100 A. Switching such kind of loads
may lead to premature wear of the actuator. In
such cases, we recommend to use switch-on
current limiters at the switching outputs.
The device may only be operated within domestic
environment, in business and trade areas as well
as in small enterprises.
If you use the device/system in a security
application it has to be operated in connection
with an UPS (uninterruptible power supply) in
order to bridge possible power failure.
Using the device for any purpose other than that
described in this operating manual does not fall
within the scope of intended use and shall
invalidate any warranty or liability.
To Next Page
Loading...
Need help?
General
