Honda 08L02-SZA-110A User Manual

Publications No.
Issue Date
INSTALLATION
INSTRUCTIONS
Accessory Application
© 2014 American Honda Motor Co., Inc. – All Rights Reserved. AII 51578 (1405) 1 of 5
08L02-SZA-1A00-90
AII 51578
ROOF RAILS
P/N 08L02-SZA-110A
2015 PILOT
MAY 2014
PARTS LIST
Left roof rail
Right roof rail
Left front roof rail cover
Right front roof rail cover
Left rear roof rail cover
Right rear roof rail cover
8Torx nuts
4 Roof molding clips
TOOLS AND SUPPLIES REQUIRED
Phillips screwdriver
Flat-tip screwdriver
Shop towel
Needle nose pliers
T-30 Torx driver
Tape measure
File
Drill
3 mm and 10 mm Drill bits
Pushpin
Eye protection (face shield, safety goggles, etc.)
The following tools are available through the Honda Tool
and Equipment Program. On the iN, click on: Service >
Service Bay > Tool and Equipment Program, then enter
the number under “Search.” Or, call 888-424-6857.
Air saw (Snap-on AT192A)
Plastic trim tool (T/N SILTRIMTL10)
Illustration of the Roof Rails on the Vehicle
QA31001AE
RIGHT
ROOF RAIL
LEFT
ROOF RAIL
www.collegehillshonda.com

Honda 08L02-SZA-110A Specifications

General

Color	Black
Part Number	08L02-SZA-110A
Category	Automobile Accessories
Manufacturer	Honda
Compatibility	Honda vehicles

Summary

Roof Rail Installation Guide

Parts List

Lists all components required for the roof rail installation, including rails, covers, nuts, and clips.

Tools and Supplies Required

Details necessary tools such as screwdrivers, drill bits, pliers, and safety equipment for the installation.

Step-by-Step Installation

Prepare Left Roof Molding Cover

Involves piercing and drilling holes in the left roof molding cover at specific marks.

Cut and Remove Left Roof Molding

Cutting the left roof molding cover with an air saw and lifting the molding off clips.

Prepare Stud Bolts and Roof Molding

Removing clips, discarding them, and cleaning excess sealant from stud bolts.

Cut Roof Molding to Size

Cutting the roof molding at specified measurements using an air saw.

Reinstall Roof Moldings and Covers

Attaching new clips, reinstalling roof moldings, and fitting the left roof molding cover.

Install Left Roof Rail

Securing the left roof rail using Torx nuts and torquing them to specification.

Attach Left Roof Rail Covers

Installing the left front and rear roof rail covers onto the left roof rail.

Install Right Roof Rail Covers

Repeating the cover installation process for the right side of the vehicle.

Repeat for Right Side

Completing the installation by repeating all steps for the right side of the vehicle.