Need help?Do you have a question about the Honda 1992 Z50R and is the answer not in the manual?
General| Displacement | 49 cc |
|---|---|
| Bore x Stroke | 39.0 x 41.4 mm |
| Compression Ratio | 8.8:1 |
| Fuel System | Carburetor |
| Ignition | CDI |
| Transmission | 3-speed |
| Final Drive | Chain |
| Front Suspension | Telescopic fork |
| Front Brake | Drum |
| Rear Brake | Drum |
| Starter | Kick |
| Weight | 50 kg (110 lbs) |
| Fuel Capacity | 2.5 liters (0.66 US gallons) |
| Carburetion | Keihin 13 mm |
| Ground Clearance | 140 mm (5.5 inches) |
| Engine Type | Air-cooled, four-stroke, single cylinder |
| Tires Front | 2.50-8 |
| Tires Rear | 2.50-8 |
| Front Tire | 2.50-8 |
| Rear Tire | 2.50-8 |
Safety precautions for operating and servicing the motorcycle.
Specified torque settings for various bolts and nuts.
Specified torque for the oil drain plug.
Step-by-step instructions for draining and refilling engine oil.
Steps to remove and take apart the oil pump for servicing.
How to inspect oil pump components for wear or damage.
Instructions for reassembling the oil pump.
Steps to install the oil pump back into the engine.
Recommended maintenance intervals and tasks for the motorcycle.
Procedure for inspecting and adjusting valve clearance when the engine is cold.
Method for testing cylinder compression using a gauge.
Detailed steps for removing the engine from the motorcycle frame.
Procedures for reinstalling the engine into the motorcycle frame.
Detailed steps for removing the cylinder head assembly.
Steps for installing the cylinder head back onto the engine.
Steps for removing the cylinder from the engine.
Procedure for removing the piston from the cylinder.
Procedures for installing the cylinder onto the crankcase.
Steps to remove the alternator from the engine.
Procedures for installing the alternator onto the engine.
Steps for separating the crankcase halves.
Procedures for assembling the crankcase halves.
Steps for removing the front suspension forks.
Procedures for removing the steering stem components.
Steps for removing and disassembling the rear wheel.
Steps for removing and disassembling rear shock absorbers.
Procedures for removing the swingarm.
Common ignition system problems and their causes.
Diagnosing and resolving issues with starting the engine.
Identifying causes for reduced engine power.
Troubleshooting issues related to weak or absent spark.
To Next Page