The parking sensor system must be
turned off before beginning this
procedure.
When you shift to reverse (R), the
LED indicator in the switch will blink
as a reminder that the rear sensors
are disabled.
Press and hold the parking sensor
system switch and then turn the
ignition switch to the ON (II)
position.
Keep pressing the switch for 10
seconds. The LED indicator in the
switch will flash.
To return to the original setting,
repeat the procedure. A beeper will
sound 3 times to confirm that the
rear sensors are now enabled.
Press the switch again and the
LED indicator will turn of f. A
beeper w ill sound twice to confirm
that the rear sensors are now
disabled.
1.
2.
3.
Canadian Owners:
This device complies with Industry
Canada Standard RSS-210. Operation is
subject to the following two conditions:
(1) this device may not cause
interference, and (2) this device must
accept any interference that may cause
undesired operation of the device.
This ISM device complies with Canadian
ICES-001.
Parking Sensor System
T o turn off all rear sensors
492
10/07/17 10:40:23 31TK8600_497
To Next Page
Loading...
Need help?
General
