Need help?Do you have a question about the Honda BF40 and is the answer not in the manual?
General| HP Rating | 40 HP |
|---|---|
| Starting System | Electric |
| Lubrication | Wet Sump |
| Trim Range | -4° to +16° |
| Gear Ratio | 2.08:1 |
| Trim & Tilt | Power Trim & Tilt |
| Displacement | 808 cc |
| Full Throttle RPM Range | 5000 - 6000 RPM |
| Fuel Delivery | Programmed Fuel Injection |
| Cooling System | Water Cooled |
| Exhaust | Through Propeller |
| Recommended Fuel | Unleaded Gasoline (86 Octane) |
| Propeller Selection (Pitch) | 9 inches |
| Shaft Length | 20 inches |
| Alternator Output | 12V |
| Fuel Tank Capacity | N/A (External) |
The official user guide for the Honda Display Assy 4.3.
Expresses gratitude and provides a general overview of the manual's scope.
Lists accessories to check before using the product.
Configures the number of outboard motors to display on the unit.
Explains how to use the main navigation buttons (MENU, BACK, navigation, ENTER).
Details display options (analog, bar, digital) for various engine parameters.
Covers graph, single, triple, and quad screen layout options.
Shows status and time remaining for maintenance notifications.
Displays active engine warnings and error levels.
Explains error indicators like Check Engine, Over Temperature, and Low Oil Pressure.
Instructions for proper storage and cleaning of the display.
Lists compatibility of features with different Honda outboard engine models.
Includes power, communication, size, and weight specifications.
An index to various configuration settings and their corresponding pages.
Sets reference speed source (Boat Speed or RPM) for trim/cruise control.
Enables or disables the automatic tilt feature for the outboard motor.
Turns the automatic trim adjustment feature ON or OFF.
Selects the trim angle pattern (None, Pattern 1-3) for trim support.
Defines the maximum upward tilt position for the outboard motor.
Defines the minimum downward trim position for the outboard motor.
Calibrates the trim sensor by setting the full down position.
Sets tank capacity and calibrates fuel level sensor for multiple tanks.
Displays time remaining until the next scheduled maintenance.
Edits the display layout of the main screen using four basic configurations.
Adjusts the display brightness in eight steps.
Configures display units for various parameters like speed, fuel, and temperature.
Sets the language for the display interface.
Resets the total fuel consumed data.
Restores system settings (excluding BOAT SET) to factory defaults.
To Next Page
