7 Changing of fuel mileage meter unit:
a
Press the
SEL
button to select “L/100 km”or
“km/L”.
If the “mph” for speed and “mile” for
mileage are selected, the fuel mileage
shown by “mile/L” or “mile/gal”.
b
To end the selection, press the
SET
button.
The fuel consumption meter unit is set, and
then the display returns to ordinary display.
The established setting can also be set by
turning the ignition switch to the
(Off)
position
The control is automatically switched from
the setting mode to the ordinary display if
the button is not pressed for about 30
seconds. Even in this case, established setting
is maintained.
20161220114015_32MJED100_eng_BOOK Page 34 Tuesday, December 20 2016 11:43:47 JST
Operation Guide
31
To Next Page
Loading...
