Storage Equipment
The helmet holder, the tool kit and helmet set wire
(in the tool kit) are located under the seat. There is
also space to store an U-shaped lock on the rear
fender using the rubber strap.
u U-shaped lock is not included with this
motorcycle.
u Use the helmet holder only when parked.
u Some U-shaped locks may not fit in the
compartment due to their size or design.
#
Removing the Seat
(P.
60)
3WARNING
Riding with a helmet attached to the
holder can interfere with the rear wheel
or suspension and could cause a crash
in which you can be seriously hurt or
killed.
Use the helmet holder only while
parked. Do not ride with a helmet
secured by the holder.
20161220114015_32MJED100_eng_BOOK Page 43 Tuesday, December 20 2016 11:43:47 JST
Operation Guide
40
Helmet set wire
Helmet set wire Helmet holder
Helmet D-ring
Rubber strap
Tool kit
U-shaped lock
To Next Page
Loading...
