7.
Apply a thin coat of engine oil to the
rubber seal of a new oil filter.
8.
Install the new oil filter and tighten.
Torque: 26 N·m (2.7 kgf·m, 19 lbf·ft)
9.
Install a new sealing washer onto the
drain bolt. Tighten the drain bolt.
Torque: 30 N·m (3.1 kgf·m, 22 lbf·ft)
10.
Fill the crankcase with the recommended
oil (2 P. 51, 2 P. 116) and install the oil fill
cap/dipstick.
Required oil
When changing oil & engine oil
filter:
2.9 L (3.1 US qt, 2.6 Imp qt)
When changing oil only:
2.6 L (2.7 US qt, 2.3 Imp qt)
11.
Check the oil level. 2 P. 61
12.
Check that there are no oil leaks.
20161220114015_32MJED100_eng_BOOK Page 67 Tuesday, December 20 2016 11:43:47 JST
Engine Oil u Changing Engine Oil & Filter
Maintenance
64
Rubber seal
Oil filter
To Next Page
Loading...
