Honda CRF50F 2004-2015 - Page 168

FRONT WHEEL/ BRAKE/SUSPENSION/ STEERING
ASSEMBLY
BACK - UP RING
SPRINGfHOLDERS
\j
ST OPPER RI NG ---------.... ~
~
DUST SEAL
FORK SUDER
OUT ER TUBE
SPRING PIN
SLIDER GUIDE
"ItJo H PISTON
Install the following onto the fork slider:
SLIDER GUIDE
- New dust seal (apply grease to the seal lips)
- Stopper ring (with the chamfered side facing up)
(5 - 6g)
- Back up ri ng
-
Slider guide (apply 5 - 6 9 of grease to the slider
guide sliding surface of the fork slider)
BACK-UP NG STOPPER RING
Install the slider piston and fork spring / holders as
shown.
Align the pin holes in the piston, fork slider and
spr
ing holde r so that the locating pin on the upper
spring holder is facing inside of the fork slider and
drive the spring pin to secure them, using a 4 mm
pin driver.
Be sure thaI the spri ng pin does not project out of
the piston outer surface.
SP RI NG PIN
12-17