Honda CRF50F 2004-2015 - Steering Stem Service

FRONT WHEEL/BRAKE /S USPENSION/STEERING
Apply 5 - 6 9 of grease to the slider guide outer
groove.
Pack the fork spring with 14 9 of grease.
Install the fork assembly by aligning the locating pin
with the groove in the outer tube.
Instal! the fork top bolt and washer and tighten it.
Wipe any excess grease of the outer tube.
Install the stopper ring into the groove in the outer
tube properly.
Install the dust seal over the outer tube.
Wipe any excess grease of the fork slider.
Install the brake cable onto the fork slider and
secure it by tightening the ca ble nut.
Install the front wheel (page 12·' 1).
STEERING STEM
REMOVAL
12-18
Remove the following:
- Number plale (page 2-5)
Handlebar (page 12·6)
Front wheel (page 12-8)
Front
fender (page 2-5)
Steering stem nut and washer.
Front
top bolts and washer.
Top bridge .
BACK-UP RING