Honda CRF50F 2004-2015 - Page 93

CYLINDER HEADIVALVES
Route the cam chain through the cylinder head and
install the cylinder head.
Install the cylinder Install a new gasket onto the cylinder head and then
head COlier with irS install the cyli nder head cover. HEAD C()VI'~ l :
arrow mark facing
down
Install the following:
- Cap nuts/new sealing washers
-
Nut/new sealing washer
• Note the position of the washers and nuts .
T
ighten the cylinder head cover nuts to the specified
t orque.
TORQUE: '1 N'm (1 .1 kgf·m, 8 Ibf.ft)
Install and tighten the cylinder head mounting bol t.
If the cylinder was removed, tighten the cylinder
moun ting bolt.
ARROW
Install a new O-ring into the groove in the intake .. - ...,,... ---- ..
manifold.
Install and tighten the intake manifo ld bolls.
Inslalilhe following:
- Spark plug (page 3-8)
-
Muffle r (page 2- 5)
- Camshaft (page 7-18)
7·17