Instruments & Controls
39
Controls & Features
Hazard Switch
The hazard switch is used to activate the hazard lights on your motorcycle if you
need to stop near heavy traffic or if your motorcycle is disabled.
To operate, turn the ignition key to the ON or ACC position, and push the hazard
switch. The front and rear turn signals will blink simultaneously until you push
the switch again.
If you anticipate using the hazard system for an extended time, use the ACC
position and turn off all unnecessary
accessories to conserve battery capacity.
Be sure to turn the switch off when the hazard warning is no longer required, or
the turn signals will not work properly and may confuse other drivers.
LEFT SIDE
(Models not equipped with
Navigation System)
hazard switch
(Models equipped with
Navigation System)
hazard switch
To Next Page
Loading...
Need help?
General
