Basic Operation & Riding
73
Starting & Stopping the Engine
Bank Angle Sensor Ignition Cut-off System
Your motorcycle’s banking (lean angle) sensor system is designed to
automatically stop the engine and fuel pump if the motorcycle is overturned.
Before restarting the engine, you must turn the ignition switch to the OFF
position and then back to ON. The engine will not restart until you perform this
procedure.
How to Stop the Engine
Normal Engine Stop
To stop the engine, shift into neutral and turn the ignition switch OFF.
The engine stop switch should normally remain in the RUN position even when
the engine is OFF.
If your motorcycle is stopped with the ignition switch ON and the engine stop
switch OFF, the headlight and taillight will remain on, resulting in battery
discharge.
Emergency Engine Stop
To stop the engine in an emergency, use the engine stop switch. To operate, turn
the switch to the OFF position.
To Next Page
Loading...
Need help?
General
