Service Information
16-1 Meter Disassembly/Assenbly 16-6
1
Service
Information
I
..,,
,,.,ogen headlight bulb becomes very hot while the headlight is
ON,
and remains hot for a while after
it
is
turned
OFF.
Be sure to let
it
cool down before servicing.
Use a flame and heated
waterlcoolant mixature for the thermo sensor inspection. Keep all flammable materials
away from the burner. Wear protective clothing.
gloves and eve orotection.
System Location 16-2 Tachometer Inspection 16-7
Headlight
Removal/lnstallation 16-3 Side Stand Switch 16-7
TailIBrake Light 16-4 Neutral Switch 16-8
Turn Signal Bulb 16-4 Ignition Switch Removal/lnstallation 16-9
Meter
Removal/lnstallation 16-5
Note the following when replacing the halogen headlight bulb.
-
Wear clean gloves while replacing the bulb. Do not put finger prints on the headlight bulb. as they may create hot
spots on the bulb and cause
it
to break.
-
If you touch the bulb with your bare hands. clean
it
with a cloth moistened with alcohol to prevent its early failure.
-
Be sure to install the dust cover after replacing the bulb.
Check the battery condition before performing any inspection that requires proper
battery voltage.
A
continuity test can be made with the switches installed on the motorcycle.
For the following component locations, see page
16-2 of this manual (System Location)
;
for inspections, refer to the
applicable pages.
I
I
Front brakelight switch
I
Section 25 of the Common Service Manual
I
Component
I
I
Horn
1
Section 25 of the Common Service Manual
I
Clutch switch
1
Section 25 of the Common Service Manual
I
Inspection method
Remarks
Handlebar switches
Ignition switch
Oil pressure
switchlwarning
light
Rear brakelight switch
Check for continuity on the continuity
chart
of the Wiring Diagram, page 17-1
Section 25 of the Common Service Manual
Section 25 of the Common Service Manual
Switch connectors are located inside the
headlight case (page 1-21)
Oil pressure check
:
Section
4
of the Com-
mon Service Manual
Oil pressure switch torque
:
12 N-m (1.2 kg-m.
9
ft-lb)
Turn signal lights
Section
25
of the Common Service Manual
3
terminal relay.
To Next Page
Loading...
Need help?
General
