Honda Nighthawk CB 750 1995 User Manual

Rear WheellSuspension
Spring, Upper Seat Removalllnstallation
lnstall the shock absorber compressor and attachment on
the shock absorber.
NOTE
-
lnstall the compressor securely against the spring and
tighten the nut securely.
a
Shock absorber compressor 07GME-0010000
(1) COMPRESSOR
Compressor attachment
07959-MB10000
I
(2) ATTACHMENT
I
Compress the shock spring and remove the upper seat.
CAUTION
I .
Do not compress the spring more than nesessary.
1
Loosen the shock absorber compressor slowly and remove
the shock absorber and attachment.
Remove the shock absorber spring.
lnstall the shock absorber spring with tightly wound coil
end facing up.
Install the special tools and compress the shock spring
lnstall the spring seat securely.
Shock absorber
com~ressor 07GME-0010000
Compressor attachment 07959-ME1 0000
NOTE
lnstall the compressor securely against the spring and
tighten the nut securelv.
Loosen the shock absorber compressor slowly and remove
the shock absorber and attachment.
'I.
(1 COMPRESSOR
(2) AmACHMENT

Honda Nighthawk CB 750 1995 Specifications

General

Displacement	747cc
Compression Ratio	9.3:1
Starting	Electric
Transmission	5-speed
Final Drive	Chain
Front Suspension	Telescopic fork
Front Brake	Dual disc
Rear Brake	Single disc
Bore x Stroke	67 x 53 mm
Ignition	Electronic
Rear Suspension	Dual shock
Fuel Capacity	18 liters
Torque	62 Nm
Engine Type	747cc air-cooled DOHC inline-4