Honda XL350R 1984 User Manual

MA INTENANCE
SPARK ARRESTER CLEANING
(U.S.A.onlvl
Remove the muffler lid.
Start the engine and increase rpm's to blow carbon
out of the exhaust pipe while momentarily creating
exhau5t system back pressure by blocking the end
of the muffler with a mop towel. Repeat until car-
bon stops coming out.
• Do not perform Ih is operation while rhe
ex haust pipe is hot ,
• Perform this operaTion in Q well ~V:'nti/.ated
area, free from th e hazord,
• Use adequate eye protection.
After cleaning the spark arrester install the muffler
lids and gasket.
NOTE
Check that the muffler lid and gasket is in
good
condition and the bohs are tightened
securely,
NUTS , BOLTS , FASTENERS
Tighten the bolts, nuts and fasteners at the interva ls
shown in the Maintenance Schedule (Page 3-3),
Check that all chassis nuts and bolts are tightened
to their correct torque val ues (Page 1-5 and 6).
Check all cotter pins and 58fety clips.
3-18
MUFFLER LID
MUFFLER LID
GASKET

Honda XL350R 1984 Specifications

General

Ignition	CDI
Final Drive	Chain
Front Suspension	Telescopic fork
Rear Suspension	Pro-Link single shock
Rear Brake	Drum
Front Tire	3.00-21
Rear Tire	4.60-17
Engine Type	single cylinder
Carburetion	Keihin
Front Brake	Disc
Seat Height	880 mm (34.6 inches)
Fuel Capacity	12 liters (3.2 gallons)
Transmission	6-speed