Flat Head Screws
To install you will need
Phillips Screwdriver
Standard Screwdriver
Drill and 1/4 in. (6.3 mm) drill bit
4 AA alkaline batteries
The push button supplied with this kit is pre-programmed to operate with the doorbell. If it is not, see “Connect a Push
Button”.
Overview
Just follow these simple steps:
1. Install batteries.
2. Set up the doorbell and your preferences.
3. Install the doorbell and the push button.
Safety
Before proceeding with the installation, please note the following safety warnings:
Always follow the manufacturer’s advice when using power tools and wear suitable protective equipment (e.g. safety
goggles) when drilling holes, etc.
Before drilling holes in walls, check for hidden electricity cables and water pipes. The use of a cable/pipe locator is
advisable if in doubt.
Install Batteries
To Next Page
Loading...
