22 23
Regulatory information
Why is the thermostat showing up as offline (strike-through WiFi icon) on top of right corner of thermostat display?
If the thermostat displays a strike-through WiFi icon on its screen or shows up as offline on the Honeywell Home app, it has lost
connection to the network. Make sure the router is powered and broadcasting. The home’s WiFi network may need to be reset
by power cycling the router. Consult the router’s instruction manual for directions on power cycling. When the network has been
restored, the thermostat will automatically reconnect.
An activation email hasn’t been received.
An email will be sent from connectedHome@alarmnet.com. An activation email is needed to complete the account setup. If an
activation email is not received after five minutes, check the Spam folder of the email account.
If you do not find it in the Spam folder, click on the Resend button and the activation email will be resent. If you still do not receive
your activation email, please contact the Technical Support team at 18006333991 for help.
Frequently Asked Questions
FCC REGULATIONS
47 CFR § 15.19 (a)(3)
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
47 CFR § 15.21 (USA only)
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
47 CFR § 15.105 (b)
See https://customer.resideo.com/enUS/support/residential/
codes-and-standards/FCC15105/Pages/default.aspx for additional
FCC information for this product.
IC REGULATIONS
RSS-GEN
This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development Canada’s
licence-exempt RSS(s). Operation is subject to the following two
conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference
that may cause undesired operation of the device.
The operation of this equipment is subject to the following two
conditions: (1) this equipment or device may not cause harmful
interference, and (2) this equipment or device must accept any
interference, including interference that may cause undesired
operation.
To Next Page
Loading...
Need help?
General
