7 - 18
Telepen
Telepen Output
Using AIM Telepen Output, the image scanner reads symbols with start/stop
pattern 1 and decodes them as standard full ASCII (start/stop pattern 1). When
Original Telepen Output is selected, the image scanner reads symbols with
start/stop pattern 1 and decodes them as compressed numeric with optional full
ASCII (start/stop pattern 2).
Default = AIM Telepen Output.
Telepen Message Length
Scan the bar codes below to change the message length. Refer to Message
Length Description (page 7-2) for additional information. Minimum and
Maximum lengths = 1-60. Minimum Default = 1, Maximum Default = 60.
UPC-A
<Default All UPC-A Settings>
Original Telepen Output
* AIM Telepen Output
Minimum Message Length
Maximum Message Length
To Next Page
Loading...
