Honeywell 4820 User Manual

4 - 12
Aimer Delay
The aimer delay allows a delay time for the operator to aim the image scanner
before the picture is taken. Use these codes to set the time between when the
trigger is pulled and when the picture is taken. During the delay time, the
aiming light will appear, but the LEDs won’t turn on until the delay time is over.
Default = Off.
User-Specified Aimer Delay
If you want to set your own length for the duration of the delay, scan the bar
code below, then set the time-out by scanning digits (0 - 4,000 ms) from the
Programming Chart inside the back cover of this manual, then scan Save.
Aimer Mode
This feature allows you to turn the aimer on and off. When the Interlaced bar
code is scanned, the aimer is interlaced with the illumination LEDs.
Default =
Interlaced.
400 milliseconds
* Off
(no delay)
200 milliseconds
Delay Duration
Off
* Interlaced

Honeywell 4820 Specifications

General

Wavelength	617 nm
Optical sensor resolution	752 pixels
Bluetooth	Yes
Standard interfaces	USB
Battery type	Lithium Ion
Input voltage	3.7 V
Certification	FCC Part 15, RSS-210, CE, GS, NOM-NYCE, COFETEL, C-Tick
Product color	Black, Grey
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	0 - 95 %

Weight and Dimensions

Weight	255 g