Need help?Do you have a question about the Honeywell 527HHON001BLK and is the answer not in the manual?
General safety precautions and warnings for installation.
Marking the roof opening location for fan installation using a pilot screw and string.
Cutting the roof opening using a drill and reciprocating saw, avoiding rafters.
Cutting shingles around the hole to accommodate flashing placement.
Cutting roof sections to allow the flashing to slide under shingles.
Applying sealant to the underside perimeter of the fan base for water tightness.
Sliding flashing under shingles and securing the fan to the roof with nails and sealant.
Adjusting the solar panel angle for maximum sunlight exposure.
Applying roofing caulking to seal edges of the base for water tightness.
Removing the old attic vent by pulling back shingles and securing fasteners.
Cleaning the roof substrate area of old materials for a tight seal.
To Next Page
General