16
EXTERIOR ASSEMBLY OVERVIEW
Indicator light
Green
Red
l
The electronic lock requires four (4) High Quality AA
Alkaline batteries. When all 4 batteries are installed
in the correct position, you will hear 2 beeps and
the keypad will illuminate blue. DO NOT TOUCH the
keypad until the keypad stops illuminating.
Batteries (not included)
Unlock button
Lock - Use to lock door
Lock button
App in order to program the keypad.
By default the factory keypad passcode is 1234
Change the Administrator passcode
AP
so
it can easily be remembered by you after
connecting to a lock.
factory keypad passcode will be changed to
a new code, which can be found in the lock’s
settings.
Unlock - Used to unlock door
Programming - Used in programming steps
VERY IMPORTANT
Received Code (69 digits)
Complete all the programming steps in the programming mode
within 5 seconds.
Use the
key to clear entries in case a wrong button is pushed.
Programming Symbols
New Code (49 digits)
Lock / Clear
Administrator Passcode
Administrator Passcode:
AP
AP
RP
NP
(Admin Passcode is located on the Honeywell App under
Lock Settings.)
Unlock / Programming
KEY PAD PROGRAMMING OPTIONAL
To Next Page
Loading...
Need help?
General
