Honeywell 9782 Series - Page 11

6/99 9782 Series Conductivity/Resistivity Analyzer/Controller - Operator’s Manual xi
Tables
Table 1-1 Key Functions.......................................................................................................................... 1-6
Table 1-2 9782 Conductivity/Resistivity Analyzer/Controller Menu Hierarchy................................... 1-11
Table 1-3 Available Combinations of Relay Assigments ...................................................................... 1-15
Table 1-4 Overview of Analyzer/Controller Installation Tasks............................................................. 1-17
Table 3-1 Procedure for Unpacking and Preparing the 9782................................................................... 3-2
Table 4-1 Procedure for Installing AC Power Wiring .............................................................................4-4
Table 5-1 Procedure for Performing I/O Setup........................................................................................ 5-6
Table 5-2 Procedure for Configuring CAT Control and/or Retransmission of Process Variables........ 5-10
Table 5-3 Procedure for Configuring On/Off Control ........................................................................... 5-13
Table 5-4 Procedure for Configuring PFT Control................................................................................5-14
Table 5-5 Procedure for Configuring DAT Control............................................................................... 5-15
Table 5-6 Procedure for Configuring Alarms ........................................................................................ 5-16
Table 5-7 Procedure for Setting the Clock............................................................................................. 5-17
Table 5-8 Procedure for Configuring AutoClean................................................................................... 5-19
Table 5-9 Procedure for Specifying a Computed Value ........................................................................ 5-21
Table 5-10 Menu Choices and System Defaults ....................................................................................5-23
Table 6-1 Recommended Maximum Wire Size....................................................................................... 6-3
Table 6-2 Procedure for Installing Analog I/O Wiring............................................................................ 6-5
Table 6-3 Relay Contact Maximum Ratings............................................................................................ 6-7
Table 6-4 Procedure for Wiring Relays ................................................................................................... 6-8
Table 6-5 Procedure for Disconnecting RC Arc Suppression Circuits.................................................... 6-9
Table 8-1 Procedure for Entering Cal Factor........................................................................................... 8-4
Table 8-2 Conductivity of Potassium Chloride Solutions at 25 °C ......................................................... 8-5
Table 8-3 Procedure for Performing Calibration Trim Using a Reference Solution............................... 8-6
Table 8-4 Procedure for Removing Calibration Trim Values.................................................................. 8-7
Table 8-5 Procedure for Entering TDS Conversion Factor...................................................................... 8-9
Table 9-1 System Status Message............................................................................................................ 9-2
Table 9-2 Process Alarm Messages.......................................................................................................... 9-3
Table 9-3 On-Line Diagnostics and System Error Messages................................................................... 9-4
Table 9-4 Procedure For Initiating Display and Keyboard Tests............................................................. 9-5
Table 9-5 Procedure for Testing Relays and Analog Outputs ................................................................. 9-7
Table 10-1 Procedure for Calibrating Outputs....................................................................................... 10-4
Table 10-2 Procedure for Specifying a Tagname or Other Display String............................................ 10-6
Table 10-3 Procedure for Viewing Product Information and Changing the Stored Model Number.... 10-7
Table 10-4 Procedure for Adjusting the Screen Contrast ...................................................................... 10-9
Table 10-5 Procedure for Entering a Password.................................................................................... 10-10
Table 10-6 Procedure for Resetting All Configuration to Factory Settings......................................... 10-11
Table 10-7 Procedure for Entering Values for Lead Resistance Compensation.................................. 10-14