Honeywell 9782 Series - Clock and Autoclean; Figure 1-5 Autoclean Display

Conductivity/Resistivity Analyzer/Controller
9782 Series Conductivity/Resistivity Analyzer/Controller - Operator’s Manual 7/991-10
Clock and AutoClean
If the 24-hour clock is turned on, a time display will be available. If AutoClean is configured,
then the AutoClean screen will be included in the display cycle (see Figure 1-5). When
AutoClean is active, the screen will display the time remaining. When this screen is on display,
the function keys can be used to control the AutoClean operation as described in 1.3.1.
AUTO CLEAN
ALARM STRIPE
START PAUSE STOP
01: 58:29
TIME REMAINING
Figure 1-5 AutoClean Display