Honeywell APT4000PH - Page 32

62
APT4000PH
Code. Parameter Setting
o1. pH/ORP unit ____________ ____________
o1. Electrode type ____________ ____________
o1. 0/4-20 mA ____________ ____________
o1. Current beginning ____________ ____________
o1. Current end ____________ ____________
o1. Filter time ____________ ____________
o1. 22mA signal ____________ ____________
o1. Hold behavior ____________ ____________
o1. Fix current ____________ ____________
o2. Unit °C / °F ____________ ____________
o2. Temp probe ____________ ____________
o2. 0/4...20mA ____________ ____________
o2. Current beginning ____________ ____________
o2. Current end ____________ ____________
o2. Filter time ____________ ____________
o2. 22mA signal ____________ ____________
o2. Hold behavior ____________ ____________
o2. Fix current ____________ ____________
tc. TC measurement ____________ ____________
tc. Measuring temp ____________ ____________
tc. TC calibration ____________ ____________
tc. TC medium ____________ ____________
CA. Cal solution ____________ ____________
CA. Cal interval ____________ ____________
AL. Sensocheck ____________ ____________
AL. Alarm delay ____________ ____________
AL. LED Hold ____________ ____________
Parameter set – user settings
63
Code. Parameter Setting
rL. Relay function ____________ ____________
L1. Contact function ____________ ____________
L1. Contact response ____________ ____________
L1. Switching point ____________ ____________
L1. Hysteresis ____________ ____________
L1. Delay ____________ ____________
L2. Contact function ____________ ____________
L2. Contact response ____________ ____________
L2. Switching point ____________ ____________
L2. Hysteresis ____________ ____________
L2. Delay ____________ ____________
Ct. Setpoint ____________ ____________
Ct. Neutral zone ____________ ____________
Ct. P action ____________ ____________
Ct. I action ____________ ____________
Ct. D action ____________ ____________
Ct. PLC/PFC controller ____________ ____________
Ct. Pulse length ____________ ____________
Ct. Pulse frequency ____________ ____________
Ct. Hold behavior ____________ ____________
Pb. EasyCLN/Rinse ____________ ____________
Pb. Rinsing interval ____________ ____________
Pb. Rinse duration ____________ ____________
Pb. Contact type ____________ ____________
Pb. Cleaning interval ____________ ____________
Pb. Calibration interval ____________ ____________
Pb. Lock interval ____________ ____________