BENDIX/KING
KAP 140
Page 3--14
Revision 2, Dec/2002
CS:15574F02
3.3.6 DISCRETE OUTPUTS SCREEN
Pressing ‘O’ when the Diagnostics Menu screen is displayed will cause the Discrete Outputs
Status screen, shown in Figure 3--7, to be displayed. Pressing the ‘ENTER’ key at this point will
return the user to the Diagnostics Menu screen.
System mode: Diagnostic
SET DISCRETE OUTPUTS
--------------------
(Enter 1 or 0 [0-7 for Audio Volume])
1 - Audio Alert 0
2 - Visual Alert 0
3 - Roll Fail Annunciator 0
4 - Pitch Fail Annunciator 0
5 - AP Annunciator 0
6 - Audio Volume 4
7 - PFT 0
8 - PFT Clear 0
9 - MET/PFT Up 0
10 - MET/PFT Down 0
11 - MET/PFT Arm 0
12 - Normal Acceleration Test 0
13 - PFT Pitch Clutch 0
14 - Roll Clutch 0
15 - Pitch Clutch 0
16 - Pitch Trim Clutch 0
Press key for desired option (<CR> to exit)
FIGURE 3--7 NO TAG DISCRETE OUTPUTS SCREEN
This screen consists of FCC discrete outputs which can be manually activated and deactivated.
This is accomplished by entering the desired option number, for example ‘15’ for Pitch Clutch. The
following message will appear.
Enter value for Pitch Clutch ():
Entering a ‘1’ will activate the discrete output, and entering a ‘0’ will deactivate it. The discrete
outputs will remain active even though the Discrete Outputs screen is exited but will automatically
deactivate if Diagnostics mode is exited.
ITEM DESCRIPTION
Audio Alert A “1” on this output generates the AP disconnect
tone to the 500 ohm output and to the TONE_ALERT
output, used to drive an external sonalert.
V isual Alert A “1” on this output turns on an external AP DISC
annunciator.
Roll Fail Annun, Pitch Fail Annun A “1” on these outputs turns on the R or P LED axis
failure indicators on the FCC.
AP Annunciator A “1” on this output “arms” the AP disconnect
alerting, causing a disconnect tone to be generated
when it is written to “0”.
To Next Page
Loading...
